Operation Manual

63Maintenance

6.4.8 Removal and installation of the steam cylinder receptacle

For removing the steam cylinder receptacle the steam cylinder must be removed rst (see chapter 6.4.3).

1. Release hose clamps and remove hoses from the connectors.

2. Undo the screw xing cylinder receptacle to the bottom of the housing with Phillips screwdriver.

3. Turn cylinder receptacle counterclockwise to the stop and remove cylinder receptacle upwards.

4. Remove snap ring and O-ring.

5. Remove O-rings on the bottom side of the steam cylinder receptacle.

The installation of the steam cylinder receptacle follows the reverse sequence of the removal. Before

mounting the steam cylinder receptacle, check O-rings and snap ring for damage and replace if necessary.

Note: Do not grease PTFE coated O-ring "A". But we recommend to grease the O-rings "B" with silicone

free grease to ease the mounting of the steam cylinder receptacle.