Operation Manual

59Maintenance
1
2
3
Assembly and installation of the steam cylinder
Assembly of the steam cylinder takes place in reverse sequence of the removal. Please note the fol-
lowing instructions:
– Installation of any heating elements which have been removed should follow the gure of step 7.
Please take care that the heating elements are correctly positioned and the cables are correctly
connected (according to your notes).
– Before installation of the steam cylinder cover place the Duro sealant around the edge of the cover.
The Duro sealant must be clean and undamaged (replace if necessary).
– Before installation of the steam cylinder in the unit check O-ring in the steam cylinder receptacle
and the snap ring for damage and replace if necessary.
– Moisten the O-ring of the steam cylinder receptacle with water (do not use grease or oil), then insert
steam cylinder into the steam cylinder receptacle and push it down to the stop.
– Insert steam cylinder in the unit correctly and fasten with clamping ring.
– Connect steam outlet hose to steam connector and fasten with hose clamp. A leaky steam outlet
hose can cause damp damage in the interior of the unit.
– Plug in heating cable plug into the plug socket and secure it with the two xing screws.
6.4.4 Removal and installation of the drain cup
For removing the drain cup the steam cylinder must be removed rst (see chapter 6.4.3).
1. Remove drain hose from the connector on the drain cup.
2. Release the hose clamp, then remove water drain hose from the connector on the drain cup.
3. Undo the two screws xing the drain cup to the unit using a screwdriver, then remove the drain cup
downwards.
Installation of the drain cup follows the reverse sequence of the removal.