Operation Manual

16 Operation
4.4.3 Draining of the steam cylinder
To perform a draining of the steam cylinder proceed as follows:
1. Press on the <Drain> button in the standard operating display. The "Manual" submenu appears.
2. In the "Manual" submenu press on the button of the cylinder(s) to be drained (<Cylinder A>, <Cyl-
inder B> or <Cylinder A/B>).
Note: on single units <Cylinder A> button is shown only.
3. Press on the <Yes> button to start the draining of the steam cylinder(s). A possible running hu-
midication process is interrupted, then the drain pump starts and empties the steam cylinder. The
progress bar in the display shows the current status of the drain cycle. After draining has nished
the unit returns to the "Manual" submenu.
Note: in order to stop the drain cycle press the <Cancel> button in the draining progress window.
The drain cycle is stopped and the unit returns to the "Manual" submenu.
4. If you have to carry out work on the Condair RS, switch off steam humidier via the unit switch.
Otherwise the steam cylinder is immediately lled again.
4.4.4 Flushing the Condair RO-A water supply system
Note: the RO ushing function in the "manual" submenu appears only, if the Condair RS is connected
to a Condair RO-A reverse osmosis system and if the reverse osmosis system was activated in the
factory menu.
To ush the RO water supply system proceed as follows:
1. Press on the <Drain> button in the standard operating display. The "Manual" submenu appears.
2. Press on the <Flush> button in the "Manual" submenu.
3. Press on the <Yes> button to start the ushing of the water supply system. The progress bar in the
display shows the current status of the ush cycle. After ushing has nished the unit returns to
normal operating mode.
Note: in order to stop the ush cycle press the <Cancel> button in the draining progress window.
The ush cycle is stopped and the unit returns to normal operating mode.