Specifications

CAUTION When replacing the battery, proper anti-static precautions must be observed.
WARNING Dispose of battery properly. DO NOT BURN.
If the battery is disconnected with out any other power, the date and time settings will need to be
initialized and SRAM data will be lost.
If the BIOS setup screens have been used to set up the board for an invalid configuration, or in
other fault conditions, it may be useful to be able to reset the contents of the CMOS RAM and
Real-Time Clock. In this case, the CMOS Clear Jumper can be used.
To clear the CMOS RAM to a known state, fit the CMOS Clear jumper and apply power. When
the board is next powered down remove the jumper, otherwise CMOS RAM will again be reset.
See Section 7.4 for additional information regarding the battery powered SRAM also fitted to this
board.
VP 110/01x 2-11
Hardware Installation