Specifications

Hardware Installation
2.1 General
This chapter contains general information on unpacking and inspecting the VP 110/01x after
shipment, and information on how to configure board options and install the board into a VME
chassis.
CAUTION It is strongly advised that, when handling the VP 110/01x and its associated
components, the user should at all times wear an earthing strap to prevent
damage to the board as a result of electrostatic discharge.
The list below outlines the steps necessary to configure and install the board. Each entry in the
list refers to a section in this chapter which will provide more details of that stage of the
procedure.
1) Unpack the board - see Section 2.2.
2) Check the board jumper and switch settings match the required operating mode - see
Section 2.3.
3) Locate the board’s indicators and switches - see Section 2.4.
4) Fit any optional mass storage or SDRAM modules - see Sections 2.5 and 2.6.
5) Fit the battery if required - see Section 2.7.
6) Fit PMC modules if required - see Section 2.8.
7) Install the board - see Section 2.9.
VP 110/01x 2-1