Specifications

B.4 AD VP2/004-20
The AD VP2/004-20 product is a 5-row P2 breakout board designed for use with the
VP 110/01x-3x VME board. It provides two IDC connectors for the PMC I/O signals on P2, and
also makes all these signals available via a single 68-way high density D-type socket. It also
provides IDC connectors for the EIDE and floppy disk interfaces, and provides a USB connector.
This breakout requires one slot width behind the backplane.
B.4.1 Layout
Figure B-2 shows the position of connectors and headers.
The AD VP2/004-20 requires a minimum of 75mm depth behind the VME backplane. This
measurement is taken from the mating face of the rear P2 connector.
B.4.2 Pin-out Tables
Floppy - Table B-2
EIDE - Table B-3
USB - Table B-4
PMC Site 1 I/O 1-32 - Table B-5
PMC Site 1 I/O 33-64 - Table B-6
PMC Site 1 I/O 1-64 - Table B-7
Breakout Modules
VP 110/01x B-3
P6
P1
VME
P5
PMC Site 1 I/O 33-64
PMC Site 1 I/O 1-64
Floppy Disk
EIDE
PMC Site 1 I/O 1-32
USB
P4
P3
P2
Figure B-2 AD VP2/004-20 P2 Breakout Connectors