Technical Specifications

TECHNICAL DATA
CRM-01
CONCROBIUM
®
MOLD CONTROL
®
2
Form: ARJ-1882
Rev.: 072419
PRODUCT APPLICATION (cont.)
APPLICATION TO ELIMINATE MOLD (cont.)
LARGE AREAS (cont.)
When water damage is suspected, first eliminate the water
source. Next remove excess water and dry surfaces
thoroughly. Concrobium Mold Control can be used on
materials removed for disposal. If excess water is removed
within 24 hours, spraying affected surfaces with product will
prevent growth. Building materials exposed to water in
excess of 24 hours may have extensive microbial growth
that is not visible. Prepare a complete assessment and
remediation plan to incorporate Concrobium Mold Control
use.
Consult the following websites for remediation
guidance:
IAQA- Indoor Air Quality Association (www.iaqa.org)
EPA- Environmental Protection Agency (www.epa.gov)
New York City "Guidelines on Assessment and Remediation
of Fungi in Indoor Environments" (www.nyc.gov)
IICRC- Institute of Inspection, Cleaning and Restoration
Certification (www.iicrc.org)
APPLICATION TO PREVENT MOLD
1. Apply Concrobium Mold Control on area until evenly wet.
2. If desired, wipe off excess wetness.
3. Allow treated surfaces to dry completely.
REAPPLICATION
Reapply weekly or when growth or odor reappears.
Determine and correct the cause of regrowth before
reapplication. Reapply Concrobium Mold Control if surfaces
are washed or painted.
STORAGE AND DISPOSAL
Store in original container in areas inaccessible to small
children. Keep securely closed. Non-refillable container. Do
not reuse or refill container. Rinse thoroughly. Recycle if
available or discard in trash.
PERFORMANCE CHARACTERISTICS
EPA Registration # 82552-1
Fungicidal test against mold and fungi.
Challenge Organisms: Aureobasidium pullutans, ATCC
9348 and T. mentagrophytes, ATCC 9533
METHOD: ASTM Quantitative Carrier Test (QCT-2)
RESULT: Achieved >99% kill level
EPA standard to validate efficacy of product to control
mold and fungal growth on hard nonporous surfaces
including tiles, wood, drywall, plastic and metal.
Challenge Organism: Aspergillus niger, ATCC 6275
METHOD: EPA Hard Surface Mildew Fungistatic Test
RESULT: No growth on treated surfaces vs. 100% growth on
control surfaces. Meets EPA requirement.
EPA Standard to validate efficacy of product to control
mold and fungal growth on articles or surfaces
composed of fabric.
Challenge Organisms: Aspergillus niger, ATCC 6275 and
Penicillium variabile, ATCC 32333
METHOD: EPA Fabric Surface Mildew Fungistatic Test
RESULT: No growth on treated surfaces vs. 100% growth on
control surfaces. Meets EPA requirement.
Industry standard test to evaluate efficacy of product to
resist mold in an environmental chamber.
Challenge Organisms: Aureobasidium pullulans ATCC
9348, Aspergillus niger ATCC 6275 and Penicillium
citrinum ATCC 9849
METHOD: ASTM D3273
RESULT: Woven Paper- no growth
Wood- No growth
Wood Composite- No growth
Drywall- No growth