MSDS

MATERIAL SAFETY DATA SHEET
CONCROBIUM MOLD STAIN ERASER
Page: 2 of 4
SECTION V: FIRE FIGHTING MEASURES
Flammability:
Non flammable.
Flash Point deg (C,TCC) :
Not Applicable
Means of Extinction:
As appropriate for surrounding fire. Use water, dry chemical, carbon dioxide or foam
Special Fire Hazards:
Fire fighters should wear self contained breathing apparatus as for surrounding fire. Oxygen
released on exothermic decomposition may support combustion in case of surrounding fire.
Autoignition
temperature:
Not applicable.
Flame propagation or
burning rate of solid:
Not applicable
Sensitivity to static
discharge:
Not applicable
Unusual Fire and
Explosion Hazards.
None expected. As per surrounding fire.
Hazardous
decomposition products:
Oxides of carbon, oxides of nitrogen.
SECTION VI: ACCIDENTAL RELEASE MEASURES
Leak and Spill
Procedures:
Before attempting clean up, refer to the hazard date provided above. Small spills may be
swept up and placed in impervious bag and disposed of in regular garbage. For large spills
sweep up and place in container with lid and dispose of in accordance to local, State or
Provincial and Federal regulations.
SECTION VII: HANDLING AND STORAGE
Storage Requirements:
KEEP OUT OF REACH OF CHILDREN. Store in a closed container away from incompatible
materials which include acids, oxidizing materials, reducing sugars and Ammonia Salts.
Storage temperature C Ambient to 35 C
Transport temperature C Ambient to 35 C
Keep container closed. Handle and open container with care. Store in a well ventilated place
away from incompatible materials. Do not store near open flame.
Do not reuse empty containers.
SECTION VIII: EXPOSURE CONTROL/PERSONAL PROTECTION
Gloves:
Impervious gloves are recommended
Eye Protection:
Splash goggles are recommended if eye contact is possible.
Respiratory Protection:
Not normally required if good ventilation is maintained
Other Protective
Equipment:
As required by employer code. Eye bath, safety shower, protective clothing.
Engineering Controls:
General ventilation normally required
SECTION IX: PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point ( deg
C)
100
Bulk Density
0.9-1.0 gr/cc
Evaporation Rate
(water=1):
Not applicable
% Volatile (Wt%):
Not
established
Solubility in water:
Complete
pH (as supplied):
Not applicable
Physical State:
powder
Viscosity:
Not
applicable
Appearance /
Odour:
White free flowing powder typical
odour