MSDS

MATERIAL SAFETY DATA SHEET
CONCROBIUM MOLD STAIN ERASER
Page: 1 of 4
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME:
Mold Stain Eraser
PRODUCT USE:
Cleans and removes stains
MANUFACTURER;
Siamons International
SUPPLIER
Siamons International
ADDRESS:
48 Galaxy Blvd
Toronto,
Ontario, Canada. M9W 6C8
ADDRESS:
48 Galaxy Blvd
Toronto,
Ontario, Canada. M9W 1A4.
EMERGENCY :
416 213 0219
EMERGENCY :
416 213 0219
Or call poison control centre listed in
white pages.
SECTION ll: INGREDIENT INFORMATION
Ingredients CAS# Wt% OSHA-TWA ACGIH-TWA LD
50
Sodium bicarbonate 144-55-8 1-5 10 mg/m3 dust resp 10 mg/m3 dust
resp
3360 mg/kg (oral/rat)
Sodium
Percarbonate
15630-89-4 60-100 10 mg/m3 dust resp 10 mg/m3 dust
resp
2400 mg/kg (oral/rat)
tetra acetyl ethylene
diamine
10543-57-4 15-35 10 mg/m3 dust resp 10 mg/m3 dust
resp
2400 mg/kg (oral/rat)
SECTION III: HAZARDOUS IDENTIFICATION
Inhalation: Remove the subject from dusty environment.
Consult a physician in case of respiratory symptoms.
Eyes: Flush eyes as soon as possible with running water for 15 minutes, while keep in
the eyelids open. In case of difficulty opening lids, administer analgesic eye-
wash (oxybuprocaine).Consult an ophthalmologist in all cases.
Skin: Remove contaminated shoes, socks and clothing; wash the affected skin with
running water. Consult a physician in case of persistent pain or redness.
Ingestion: Consult a physician immediately in all cases.
If the subject is completely conscious: Rinse and administer fresh water. Do not induce vomiting.
If the subject is unconscious: NEVER GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON.
Loosen collar and tight clothing; lay the victim on his/her left side.
Keep warm (blanket).
Chronic Effects
Carcinogenicity:
No ingredients listed IARC or NTP or ACGIC. Non hazardous by WHIMIS/OSHA
criteria.
Teratogenicity, Mutagenicity,
Reproductive Effects:
The ingredients in this product were found not to be mutagenic when tested by the
Ames Assay, ( OECD Guidelines for chemical testing, sec.471)
SECTION IV: FIRST AID MEASURES
Eye Contact:
Immediately flush with water for 15 minutes. Holding eyelids open during flushing. If irritation
persists, repeat flushing and obtain medical attention immediately.
Skin Contact :
Flush with water. Seek medical attention if irritation persists. Remove contaminated clothing and
launder before reuse.
Inhalation:
Move victim to fresh air. If conscious, have victim take deep, slow breaths. Seek medical attention
if symptoms persist.
Ingestion:
DO NOT INDUCE VOMITING. Rinse mouth with water, then drink one glass of water. Seek
medical attention. Do not give anything to victim if unconscious or convulsing.