User manual

5.6 Set GPS data upload interval
(1) Upload by interval
The default upload interval is 20 seconds, which means every 20 seconds the terminal will upload
its location data to the platform. The interval can be set by sending SMS command: TIMER,T1,T2#
(5≤T≤18000 seconds)
e.g. TIMER,20,30#
It means when ACC is on, GPS data upload interval is 20 seconds; when ACC is off, GPS data
upload interval is 30 seconds.
(2) Upload by distance
Send SMS command: DISTANCE,D# (100≤D≤10000 meters)
e.g. DISTANCE,300#
It means for every 300 meters, the terminal will upload GPS data to platform.
NOTE: if the upload interval is short, the GPRS current will add up. Please set the suitable upload
interval.
5.7 Corners upload (ON as default)
The terminal will upload GPS data to the platform when the vehicle is turning (the turning angle
reaches the pre-set value).
NOTE: if the speed is too low during turning, the GPS data will be not able to upload to the
platform.
Send SMS command: ANGLEREP,OFF# to turn it off.
5.8 Arm time interval
When the vehicle is turned off (ACC low) and stays off in 3 minutes, the terminal will enter arm
status. During this status, if the terminal detects 6 vibrations (default) and the vehicle still stays
off (ACC off) in 30 seconds, it will activate vibration alarm.
Send SMS command: DEFENSE,T# (1≤T≤60 minutes)
e.g. DEFENSE,15#
It means after 15 minutes the vehicle is turned off, the terminal will enter defense mode.
5.9 Reboot the terminal
Send SMS command: RESET#
When the terminal receives the command, it will reboot in 20 seconds.