User manual

Strona 9 z 12 rev. 1.0.2
USER MANUAL: GT06N GPS VEHICLE TRACKER
www.elmic.pl
,
[e-mail]
10. GPRS time interval
The default GPRS time sending interval is 10s which means the device will upload positioning data to the platform server
every 10s. Users can modify GPRS time sending interval by SMS “TIMER,time(second)#”.
The time ranges from 10-18000s
For example: TIMER,10#
It means the device will upload data to the server every 10s.
11. Sensor alarm time setting
When the vehicle power is off and ACC is in low-level, if ACC is off over 10 minutes, the device will enter sensor alarm
state. In this case, if the vehicle vibrates for a few times, it will activate the vibration alarm system. If the vehicle battery is
still not on (ACC is in low level) after 3 minutes, the device will start vibration alarm.
SMS format: “DEFENSE,TIME(minutes)#” The time ranges from 1 to 60 mins.
For example: DEFENSE,15#. It means when ACC is in low level for 15mins, it will enter sensor alarm status (vehicle power is
off)
NOTE
：
1. Preset SOS numbers when send SMS alarm messages and calls
2. If there is no need for vibration alarm, please SMS SENSOR,0# to close it.
12. Restore to factory setting
SMS command format: “FACTORY#” to set all parameter to default factory value. Once received “OK”, it succeeds.
13. Reboot device
When there is something wrong with the link of GPRS, e.g., The parameter setting of the device is correct, but you can't
track the car on the platform. At this moment you can send a command to the device to reboot the device.
The format is: RESET#
After receiving this command, the device will reboot after 1mins.
Operation of device
1. Power on/ Power off
Power on: Once insert a valid SIM card and connect all the wires, turn on the device, then Power LED will flash first, During
signal searching process, GSM and GPS LED will flash. Once GPS LED keeps solid light, it means the device has been located
and it starts to work.
Power off: Just turn off the power switch.
The device will begin to upload positioning data to server once inserting a valid SIM card and power on. During the
working time, it can upload data to server every 10 seconds.
2. Check location
1. Via SMS
1.1 SMS “WHERE#”, to the SIM number of device. The device will send a location message automatically. You can get the
coordinates. If the device does not search any information of location, it will send “No data” to the cell phone.
Example:
Lat:N22.571285,Lon:E113.877115,Course:42.20,Speed:0.0740,DateTime:10-11-23 22:28:51
1.2 SMS “URL#”, to the SIM number of device. The device will send a location Google Map link. If the device does not
search any information of location, it will send “No data” to the cell phone.
Example:
<Date Time
：
10-11-23 23:42:51> http://maps.google.com
/maps?q=N22.571490,E113.877103
2. Via platform
Go to the platform website offered by dealers to check your vehicle location.
3. SOS alarm
In emergent case, press SOS for 3s to activate SOS alarm. Then the device will send SOS SMS to preset specific numbers
and then dial the numbers in circles until the call is picked up. At the meantime, the device will upload SOS alarm data to
the server. And it will send:
SOS Alarm! <DateTime:11-06-17 14
： 53 ： 06> ， http://maps.google.com/maps?q=N22576713,E113.916585
Note: The specific numbers should be preset, just refer to 4