User manual

Strona 7 z 12 rev. 1.0.2
USER MANUAL: GT06N GPS VEHICLE TRACKER
www.elmic.pl
,
[e-mail]
5. Power/ACC/Tele-cutoff(petrol/electricity) control line (4 pin)
1. Your device comes with a power cord and is designed to use only manufacturer-specified original device. The red line is
positive while the black one is negative (the side should not be connect with ground wire).
2. The ACC line (white) connects to ACC switch of the vehicle. Please be sure to connect the ACC line; otherwise the device
will enter ignition detection status when disconnect the ACC line. If you don’t need to anti-theft temporarily, just connect
the ACC line to the positive side in parallel.
3. Tele-cutoff (petrol/ electricity) control line (yellow) is connected to pin 86 of the Tele-cutoff (petrol/ electricity) relay
(equal to the yellow line of the relay socket).
4. USB cable (3 pin)
Firmware updating interface/expanded function to reserve space.
5. MIC line (2 pin)
Externally connect to microphone for voice monitoring function.
6. SOS line (2 pin)
Externally connect to SOS switch for SOS function.
Quick Operation Instructions
Operation Tips: To properly use the device, common parameters should be set before initial use. This can be done by using
the parameter editor or by sending SMS commands to the device. (“,"should be English comma and no space before and
after the comma)
1. APN setting
To connect default platform www.gpsyeah.com, please send the SMS command below:APN command format: APN,APN's
Name#
E.g: APN,internet# (“internet” is the APN of carrier)
The device will reply “OK” if setting successfully.
Note: The APN of some countries have user name and password, you may need to send SMS command as following:
APN,APN name,user name,password#
E.g: APN,internet,CLIENTE,AMENA#
2. DNS setting
To connect other platform, please send the two SMS commands bleow:
Command format ：
APN,APN's Name#
SERVER,1,DNS,Port,0#
E.g: APN,internet#
SERVER,1,www.gpsluckly.com,0088,0# (for internet platform www.gpsyeah.com)
It will reply “OK” after set successfully.
3. ON /OFF GPRS
When you want to disable GPRS, you can SMS command to the SIM card number which used in the device.
Command format:
GPRS ON ： GPRSON,1#
GPRS OFF ： GPRSON,0#
It will reply “OK” after set successfully.
4. Add specific number
SMS command to the device to set the SOS number.
SOS,A,No.1,No.2,No.3#
“A” means to add new numbers, for example:
SOS,A, 13510905991,13510905992,13510905993#
If there is only one SOS number, you can appoint a specific number as SOS number. And the null means no adding.
For example:
SOS,A,13510905991# means to set the first number as SOS number
SOS,A,,13510905992# means to set the second number as SOS number
SOS,A,,,13510905993# means to set the third number as SOS number
If set successfully, there is a “success” reply SMS.