INSTRUCTION MANUAL Manual

4140
Pull the belt taut so that the lap belt and diagonal belt are well positioned and ensure
that the belts are not twisted. The lap belt should be in the lowest possible position.
Ifyourvehicleisfittedwithaseatbeltheightadjuster,adjustitsheightaccordingly.
Whenyouwishtoreleasethechildfromtheseat,allyouneedtodoisopenthelock
andpassthestrapbackacrossthechild.Toremovetheshoulderbeltfromtheguide,
presstheshoulderbeltlockingbutton(05) and pull the belt forwards and out.
Itisimportanttoensurethatthebeltsarealwayscorrectlypositionedeachtimetheseat
isused.Ifindoubtaboutanyaspectoffitting,checkwithCONCORD.
Thebeltsmustpassthroughtheguidesmarkedinredontheseat.Beltsmustnotbe
routedinanyotherway.
_ CArE iNSTrUCTiONS
Thecovercanberemovedforwashing.
Todoso,movetheheadsection(01) to its highest
position.Toremove,pullthecoverawayfromits
anchoringpoints.Beginbyremovingtheheadsection
(01)followedbytheseatsectionandtheshoulder
shields(02).
To replace, start with the cover for the seat section.
Firstly,pullthecoveroverthecoverpanelonthe
backrest,andthen,fromthefront,pullitoverthe
armrestsandseatsection.Securethecoverusingallof
the fastening points and the zip fastener on the back.
Finally,attachthecoverfortheheadsection(01) and
shouldershields(02).
•Whentheycomeintocontactwithmoisture,
 especiallyduringwashing,thecoverfabricsmay
 fadeslightly.
•Donotusesolvents!