SAFETY DATA SHEET P851 Section 1. Identification Product name Product code : Interior/Exterior Industrial Strength Alkyd Rust Control Metal Primer White : P851 Other means of : Not available. identification CAS # : Not applicable. Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Not applicable. Manufacturer : Conco Paints 101 Prospect Avenue N.W.
Section 2. Hazards identification Prevention Response Storage Disposal Supplemental label elements Hazards not otherwise classified : Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves. Wear eye or face protection. Wear protective clothing. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
Section 4. First aid measures Description of necessary first aid measures Eye contact Inhalation Skin contact Ingestion : Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10 minutes. Get medical attention. : Remove victim to fresh air and keep at rest in a position comfortable for breathing.
Section 5. Fire-fighting measures Extinguishing media Suitable extinguishing media : Use dry chemical, CO₂, water spray (fog) or foam. Unsuitable extinguishing media : Do not use water jet. Specific hazards arising from the chemical Hazardous thermal decomposition products Special protective actions for fire-fighters Special protective equipment for fire-fighters : Flammable liquid and vapor.
Section 7. Handling and storage Precautions for safe handling Protective measures : Put on appropriate personal protective equipment (see Section 8). Avoid exposure obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not get in eyes or on skin or clothing. Do not breathe vapor or mist. Do not swallow. Use only with adequate ventilation. Wear appropriate respirator when ventilation is inadequate.
Section 8. Exposure controls/personal protection TWA: 2 mg/m³ 8 hours. Form: Respirable fraction ACGIH TLV (United States, 3/2016). TWA: 20 ppm 8 hours. NIOSH REL (United States, 10/2013). TWA: 100 ppm 10 hours. TWA: 435 mg/m³ 10 hours. STEL: 125 ppm 15 minutes. STEL: 545 mg/m³ 15 minutes. OSHA PEL (United States, 6/2016). TWA: 100 ppm 8 hours. TWA: 435 mg/m³ 8 hours. NIOSH REL (United States, 10/2013). TWA: 150 ppm 10 hours. TWA: 530 mg/m³ 10 hours. OSHA PEL (United States, 6/2016). TWA: 200 ppm 8 hours.
Section 8. Exposure controls/personal protection CA Quebec Provincial (Canada, 1/2014). TWAEV: 100 ppm 8 hours. TWAEV: 434 mg/m³ 8 hours. STEV: 150 ppm 15 minutes. STEV: 651 mg/m³ 15 minutes. CA Ontario Provincial (Canada, 7/2015). STEL: 150 ppm 15 minutes. TWA: 100 ppm 8 hours. CA Saskatchewan Provincial (Canada, 7/2013). STEL: 150 ppm 15 minutes. TWA: 100 ppm 8 hours. Ethylbenzene CA Alberta Provincial (Canada, 4/2009). 8 hrs OEL: 100 ppm 8 hours. 8 hrs OEL: 434 mg/m³ 8 hours.
Section 8. Exposure controls/personal protection Hygiene measures Eye/face protection : Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Wash contaminated clothing before reusing. Ensure that eyewash stations and safety showers are close to the workstation location.
Section 9. Physical and chemical properties Viscosity : Kinematic (40°C (104°F)): <0.205 cm2/s (<20.5 cSt) Molecular weight : Not applicable. Aerosol product Heat of combustion : 6.744 kJ/g Section 10. Stability and reactivity Reactivity : No specific test data related to reactivity available for this product or its ingredients. Chemical stability : The product is stable. Possibility of hazardous reactions : Under normal conditions of storage and use, hazardous reactions will not occur.
Section 11. Toxicological information Ethylbenzene Eyes - Severe irritant Rabbit - Skin - Mild irritant Rabbit - Methyl n-Propyl Ketone Skin - Mild irritant Rabbit - Methyl Isobutyl Ketone Eyes - Moderate irritant Rabbit - Eyes - Severe irritant Skin - Mild irritant Rabbit Rabbit - Intermittent 500 milligrams 24 hours 15 milligrams 405 milligrams 24 hours 100 microliters 40 milligrams 24 hours 500 milligrams - Sensitization Not available. Mutagenicity Not available.
Section 11.
Fertility effects : No known significant effects or critical hazards. Numerical measures of toxicity Acute toxicity estimates Route ATE value Oral Inhalation (gases) 11375.7 mg/kg 48406 ppm Section 12.
Section 13. Disposal considerations Disposal methods : The generation of waste should be avoided or minimized wherever possible. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Dispose of surplus and non-recyclable products via a licensed waste disposal contractor.
Section 14. Transport information Ship type : Not available. Pollution category : Not available. Section 15. Regulatory information SARA 313 SARA 313 (40 CFR 372.45) supplier notification can be found on the Environmental Data Sheet. California Prop. 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Section 16. Other information Hazardous Material Information System (U.S.A.
Section 16. Other information It is recommended that each customer or recipient of this Safety Data Sheet (SDS) study it carefully and consult resources, as necessary or appropriate, to become aware of and understand the data contained in this SDS and any hazards associated with the product. This information is provided in good faith and believed to be accurate as of the effective date herein. However, no warranty, express or implied, is given.