SAFETY DATA SHEET P801 Section 1. Identification Product name Product code : Interior/Exterior Industrial Strength Acrylic Prime and Finish White : P801 Other means of : Not available. identification CAS # : Not applicable. Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Not applicable. Manufacturer : Conco Paints 101 Prospect Avenue N.W.
Section 2. Hazards identification Disposal Supplemental label elements Hazards not otherwise classified : Dispose of contents and container in accordance with all local, regional, national and international regulations. WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Adequate ventilation required when sanding or abrading the dried film.
Section 4. First aid measures Most important symptoms/effects, acute and delayed Potential acute health effects Eye contact : No known significant effects or critical hazards. Inhalation : No known significant effects or critical hazards. Skin contact : No known significant effects or critical hazards. Ingestion : No known significant effects or critical hazards. Over-exposure signs/symptoms Eye contact : No specific data. Inhalation : No specific data. Skin contact : No specific data.
Section 6. Accidental release measures Personal precautions, protective equipment and emergency procedures For non-emergency personnel : No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilled material. Avoid breathing vapor or mist. Provide adequate ventilation. Wear appropriate respirator when ventilation is inadequate.
Section 8. Exposure controls/personal protection Control parameters Occupational exposure limits (OSHA United States) Ingredient name Exposure limits Titanium Dioxide ACGIH TLV (United States, 3/2016). TWA: 10 mg/m³ 8 hours. OSHA PEL (United States, 6/2016). TWA: 15 mg/m³ 8 hours. Form: Total dust ACGIH TLV (United States, 3/2016). TWA: 10 ppm 8 hours. Form: Inhalable fraction and vapor OSHA PEL Z3 (United States, 6/2016). TWA: 250 mppcf / (%SiO2+5) 8 hours.
Section 8. Exposure controls/personal protection Eye/face protection : Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts. If contact is possible, the following protection should be worn, unless the assessment indicates a higher degree of protection: safety glasses with sideshields.
Section 10. Stability and reactivity Reactivity : No specific test data related to reactivity available for this product or its ingredients. Chemical stability : The product is stable. Possibility of hazardous reactions : Under normal conditions of storage and use, hazardous reactions will not occur. Conditions to avoid : No specific data. Incompatible materials : No specific data.
Section 11. Toxicological information Name Category Route of exposure Target organs 2-(2-Butoxyethoxy)-ethanol Category 3 Not applicable. Respiratory tract irritation and Narcotic effects Name Category Route of exposure Target organs 2-(2-Butoxyethoxy)-ethanol Crystalline Silica, respirable powder Category 2 Category 1 Not determined Inhalation Not determined Not determined Specific target organ toxicity (repeated exposure) Aspiration hazard Not available.
Acute toxicity estimates Route ATE value Oral Dermal 44249.6 mg/kg 197359.1 mg/kg Section 12.
Section 14. Transport information Transport hazard class(es) - - - - - Packing group - - - - - Environmental hazards No. No. No. No. No. Additional information - - - - - Special precautions for user : Multi-modal shipping descriptions are provided for informational purposes and do not consider container sizes. The presence of a shipping description for a particular mode of transport (sea, air, etc.), does not indicate that the product is packaged suitably for that mode of transport.
Section 16.