SDS

Section 2. Hazards identification
Prevention
:
Obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Wear protective gloves. Wear eye or face protection.
Wear protective clothing. Keep away from heat, hot surfaces, sparks, open flames and
other ignition sources. No smoking. Use explosion-proof electrical, ventilating, lighting
and all material-handling equipment. Use only non-sparking tools. Take precautionary
measures against static discharge. Keep container tightly closed. Use only outdoors or
in a well-ventilated area. Do not breathe vapor.
Response
:
Get medical attention if you feel unwell. IF exposed or concerned: Get medical
attention. IF INHALED: Remove person to fresh air and keep comfortable for breathing.
Call a POISON CENTER or physician if you feel unwell. IF SWALLOWED:
Immediately call a POISON CENTER or physician. Do NOT induce vomiting. IF ON
SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water or
shower.
Storage
:
Store locked up. Store in a well-ventilated place. Keep cool.
Disposal
Dispose of contents and container in accordance with all local, regional, national and
international regulations.
General
:
Read label before use. Keep out of reach of children. If medical advice is needed, have
product container or label at hand.
Hazards not otherwise
classified
:
None known.
Please refer to the SDS for additional information. Do not transfer contents to other
containers for storage.
Supplemental label
elements
DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Contains solvents which
can cause permanent brain and nervous system damage. Intentional misuse by
deliberately concentrating and inhaling the contents can be harmful or fatal. WARNING:
This product contains chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm. Adequate ventilation required when sanding or
abrading the dried film. If Adequate ventilation cannot be provided wear an approved
particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for
respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading
or sanding of the dry film may release Crystalline Silica which has been shown to cause
lung damage and cancer under long term exposure.
Section 3. Composition/information on ingredients
Isoparaffinic HC Solvent
≥10 - ≤25
64742-48-9
Titanium Dioxide
≥10 - ≤25
13463-67-7
Lt. Aliphatic Hydrocarbon Solvent
≤5
64742-89-8
Ingredient name
CAS number
% by weight
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health and hence require reporting in this section.
Other means of
identification
:
Not available.
Substance/mixture
CAS number/other identifiers
:
Occupational exposure limits, if available, are listed in Section 8.
Mixture
Any concentration shown as a range is to protect confidentiality or is due to batch variation.
Date of issue/Date of revision
:
3/27/2016
Date of previous issue
:
11/27/2015
Version
:
2
2/12