Technical Specifications

ManualsBrandsConco ManualsInterior Paint & StainPro® Industrial Strength Coating 8500 Gloss Bright White/Pastel Base DTM Alkyd Paint - 5 gal.

Conco® 8500 Series Interior/Exterior Alkyd Gloss is an industrial strength coating designed for new construction and

maintenance applications. Conco 8500 Series is a high solids, low VOC, high gloss formula highly resistant to

abrasion, corrosion and a variety of chemicals with excellent chip and flake resistance. Confidently coat machinery,

equipment, piping, doors and trim with this high performance coating.

8500 SERIES

INDUSTRIAL STRENGTH COATING

INTERIOR/EXTERIOR HIGH GLOSS

BRIGHT WHITE/PASTEL BASE, ACCENT BASE, SAFETY RED, SAFETY YELLOW, ALUMINUM, BLACK

FEATURES

• Industrial strength coating designed for new construction and

maintenance applications

• Ideal for painting over prepared metal, wood, masonry,

nterior plaster and drywall

• Provides superior corrosion resistance

• Excellent chip and flake resistance

• Outstanding abrasion resistance

• Easily maintained

• Direct to metal

• Backed by 100% Satisfaction Assured W

arranty

TECHNICAL DATA*

Vehicle: Alkyd

Finish: >75 units @ 60°

Flash Point: N/A

Weight Solids: 72% ± 2%

Volume Solids: 59% ± 2%

Dry Time (@ 77°F and 50% R.H.)

To Touch: 4 Hours

To Recoat: 16 Hours

Weight Per Gallon: 9.7 lb/gal

VOC: 320 g/L –2.67 lb/gal

as per 40 CFR 59.406

Spread Rate: 241-482 sq.ft. per gallon

(dependent on surface texture and porosity)

Film Thickness: @ 7 mils wet; 3.5 mils dry

Sizes: Gallons, 5 Gallons (Special Order)

*Technical Data based on Bright White/Pastel Base

APPLICATION

Do not apply when air, surface or product temperature is below

50°F or above 110°F, when relative humidity exceeds 85%, or

when rain is forecasted within 16-24 hours of painting.

Temperature must be at least 5°F above dew point.

Spray – Airless

Pressure 1800 psi

Tip .017” - .019”

Reduce with Xylene for spray only, up to 3%

Brush

Use a quality nylon/polyester brush.

Roller

Use a 1/4” - 3/8” nap synthetic roller cover.

RECOMMENDED SYSTEMS

Ferrous Metal

1 coat Conco P851 DTM Alkyd Rust Control Metal Primer or

1 coat Conco P801 DTM Acrylic Prime and Finish