SDS

Section 16. Other information
4/28/2016
History
Date of printing
Date of issue/Date of
revision
Version
It is recommended that each customer or recipient of this Safety Data Sheet (SDS) study it carefully and consult
resources, as necessary or appropriate, to become aware of and understand the data contained in this SDS and
any hazards associated with the product. This information is provided in good faith and believed to be accurate
as of the effective date herein. However, no warranty, express or implied, is given. The information presented
here applies only to the product as shipped. The addition of any material can change the composition, hazards
and risks of the product. Products shall not be repackaged, modified, or tinted except as specifically instructed
by Sherwin-Williams, including but not limited to the incorporation of non Sherwin-Williams products or the use
or addition of products in proportions not specified by Sherwin-Williams. Regulatory requirements are subject
to change and may differ between various locations and jurisdictions. The customer/buyer/user is responsible to
ensure that his activities comply with all country, federal, state, provincial or local laws. The conditions for use
of the product are not under the control of the manufacturer; the customer/buyer/user is responsible to
determine the conditions necessary for the safe use of this product. The customer/buyer/user should not use the
product for any purpose other than the purpose shown in the applicable section of this SDS without first
referring to the supplier and obtaining written handling instructions. Due to the proliferation of sources for
information such as manufacturer-specific SDS, the manufacturer cannot be responsible for SDSs obtained from
any other source.
Notice to reader
Date of previous issue
:
:
:
:
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL = International Convention for the Prevention of Pollution From Ships, 1973
as modified by the Protocol of 1978. ("Marpol" = marine pollution)
UN = United Nations
4/28/2016
3/27/2016
2.02
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4
representing significant hazards or risks Although HMIS® ratings are not required on SDSs under 29 CFR 1910.
1200, the preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS®
program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA). HMIS® materials may
be purchased exclusively from J. J. Keller [phone].
Procedure used to derive the classification
Classification
Justification
CARCINOGENICITY - Category 1A
Calculation method
Date of issue/Date of revision
:
4/28/2016
Date of previous issue
:
3/27/2016
Version
:
2.02
10/10