User's Manual

58
If you need the print server to automatically get an IP from DHCP server, select “Enable Obtain TCP/IP
Settings Automatically (Use DHCP/ BOOTP)”. You also can select “Disable Use the following TCP/IP
Settings” to manually assign “IP Address”, “Subnet Mask” and “Gateway” for the print server.
You can enable/disable or set auto for the print server’s DHCP server. The DHCP server is disabled by
default. If the DHCP Server is enabled or set Auto, you have to assign a range of IP addresses here. Fill in
the “Start IP”, “Range”, “DNS”, “Subnet Mask” and “Gateway”, and the print server will assign a
unique IP for each client. Note that when “Auto” is selected, the DHCP Server of the print server will be
enabled only when there is no other DHCP Server within the network.
8.4.5 SMB
You can enable/disable the SMB protocol from here. If SMB is enabled, enter the “SMB Group Name” to
specify the SMB group that this print server belongs to. All PC should join the same group before they
can use this print server by SMB protocol.
8.4.6 SNMP