User manual

9
1. To support the remote monitor/control function of WinPower, you need to have the similar
connection as above. It means that the Agent is connected to the UPS via RS232/USB and
the other Computers are protected via the AC Power only and all the computers are
communicated under the same Network with LAN.
2. All the computers need to install the WinPower software to keep them with the same interface
for remote shutdown application. If you don’t install the WinPower on them then
you would not able to do the remote monitor/control.
3. Owing to the fact that there is no RS232 cable connect to PC-A ~ PC-C, so you will see the
message of “no connection”. Moreover, you would find that these PC is without the in
the front of the PC listed in the WinPower monitor screen as below.