User manual

ENGLISH
71
Reboot System
The following window is used to restart the Switch.
Figure 10- 7. Reboot System window
Clicking the Yes radio button will instruct the Switch to save the current configuration to non-volatile RAM before
restarting the Switch.
Clicking the No radio button instructs the Switch not to save the current configuration before restarting the Switch.
All of the configuration information entered from the last time Save Changes was executed, will be lost.
Click the Restart button to restart the Switch.
Save Changes
The Switch has two levels of memory, normal RAM and non-volatile or NV-RAM. Configuration changes are made
effective clicking the Apply button. When this is done, the settings will be immediately applied to the switching
software in RAM, and will immediately take effect.
Some settings, though, require you to restart the Switch before they will take effect. Restarting the Switch erases
all settings in RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes
to NV-RAM before rebooting the switch.
To retain any configuration changes permanently, click on the Save button in the Save Changes page, as shown
below.
Figure 10- 8. Save Changes window