User manual

ENGLISH

9. After you have correctly set up the terminal, plug the power cable into the power receptacle on the back

of the Switch. The boot sequence appears in the terminal.

10. After the boot sequence completes, the console login screen displays.

11. If you have not logged into the command line interface (CLI) program, press the Enter key at the User

name and password prompts. There is no default user name and password for the Switch. The administrator

must first create user names and passwords. If you have previously set up user accounts, log in and

continue to configure the Switch.

12. When you have completed your tasks, exit the session with the logout command or close the emulator

program.

13. Make sure the terminal or PC you are using to make this connection is configured to match these settings.

If you are having problems making this connection on a PC, make sure the emulation is set to VT-100. You will be

able to set the emulation by clicking on the File menu in you HyperTerminal window, clicking on Properties in the

drop-down menu, and then clicking the Settings tab. This is where you will find the Emulation options. If you still

do not see anything, try rebooting the Switch by disconnecting its power supply.

Once connected to the console, the screen below will appear on your console screen. This is where the user will

enter commands to perform all the available management functions. The Switch will prompt the user to enter a

user name and a password. Upon the initial connection, there is no user name or password and therefore just press

enter twice to access the command line interface.

CB100S48S Fast Ethernet Switch Command Line Interface

Firmware: Build 1.00-B11

UserName:

Figure 4- 1. Initial screen after first connection