User manual

18
【Channel】Choose need to set up mobile testing area passage "whole" says setting all channels
【Sensitivity Setting】Can be set to give: minimum, low, general, high, highest
【Detection Area】Click Settings enter.
Green area for dynamic test, grey areas design.ferroconcrete-brick undefended area for. Press the mouse left key to drag on the lower detection area to the right,
press the mouse button clearance. Detection area drag The save and exit button can save Settings, some give up and quit button abandon modification.
【Buzzer Alarm】Occur when dynamic test on the buzzer whether to allow the alarm
【Trigger Recording】That will happen when dynamic test on the linkage of selected channel fast ball trigger video
【Alarm Output】In this passage setting user can be copied to the other channels, fulfill the same dynamic detection alarm Settings
4.3 Network Setup
(1)General Setup
【DHCP】After checked automatic assignment device will get IP address, subnet mask, the default gateway, the DNS server, etc
【UPnP】Can choose according to the requirement
【IP Address】Network logic address can according to the requirements set
【Subnet Mask】Server subnet mask
【Default Gateway】Server gateway
【DNS Server】DNS server addresses
【Server Port】Data port, initial socket for 7777
【HTTP Port】the default port for 80. If change, when using IE browser, need to monitor the IP address, adding new socket. If use IP address to 82, from the original
browsing http://192.168.0.19, change for http://192.168.0.19:82.
【Handset Port】Network phones socket, initial socket for eight thousand eight hundred and eighty eight
(2)Dial-UP Setup