User manual

13
3.8 How to control PTZ
【Zoom】Lens in the current play far closer picture, use the mouse wheel also can undertake variable times control.
【Focus】Slight adjusting the focal length
【Iris】Aperture size adjustment
【Speed】Through the slider adjust rotation stepinterval, yuntai mainly used to control direction operation, the step length of turning the faster yuntai.
【Preset】Adjust the camera Angle, then direction and the corresponding input and clicking on [ set] button, preset dots to set the dots in the preset rastelli.
Input presets dots and click on [Transfer] button, the camera will be transferred to the preset point corresponding position.Click[remove ] button, this presets dianjiang
be cleared
【Set】Click 【Start Tour】 the trajectory of said no corresponding, click the 【 add Preset 】 and 【 delete Preset point 】, 【Clear Tour】 the cruise lines.
【Start Tour】begin to track record, was registered date 【 end Tour】， thus set up from the corresponding track circuit.
【Left Limit】Began to limit scanning Settings, was registered date 【 right Limit 】, thus set up corresponding limit scanning.
【Add Preset】Add presets point to the cruise lines.
【Delete Preset】Cruise lines from deleting preset points.
【Clear Tour】Remove the cruise line designated.
Note: some equipment doesn't fully support all function, depending on the specific yuntai equipment and different.
【Control】PTZ Control
【Tour Scan】Point between cruise control.
【Pattern Scan】Track patrol control.
【PTZ Reset】Remove all Settings, original reset to the original state.
【Limit Scan】Yuntai boundary scan control around.
【Auto Pan】Remove the cruise line designated
Note: some equipment doesn't fully support all function, depending on the specific yuntai equipment and different.