Network Hardware User Manual

1. Connect the Wireless Access Point to a Broadband connection (i.e.,

a Cable modem or a DSL modem.)

2. Install the C54U Wireless USB Stick Adapter in the computer(s) on

your wireless network

3. Check the Device Manager to confirm that the wireless adapter is

installed correctly. Please refer to the Networking Basics section

in this manual entitled: Checking the Installation of the Drivers for

the Wireless Adapter.

4. Set the Static IP Address of the wireless adapters if Multiple

Dynamic IP are not used.

Note: The IP Address for all computers must be in the same IP Address

range, and the Subnet Mask must be the same for all the computers on the

network. For example: If the first computer is assigned an IP Address of

10.0.0.2 with a Subnet Mask of 255.0.0.0, then the second computer can

be assigned an IP Address of 10.0.0.3 with a Subnet Mask of 255.0.0.0, etc.

If you are using a PPPoE client (Point to Point Protocol over Ethernet),

please contact your ISP (Internet Service Provider) for further instructions

regarding connecting to the Internet.