Network Hardware User Manual

This type of installation requires that you provide a dynamic IP address for

each computer on your network. You will need a DHCP-capable

Residential Gateway/Router for your network.

To complete the installation, please follow these steps:

1. Connect the Router/Gateway to a Broadband connection (e.g., a

Cable modem or a DSL modem.)

2. Connect the 802.11g Access Point to the router.

3. Install the C54U Wireless USB Stick Adapter into a laptop or

desktop computer on your wireless network

4. Check the Device Manager to confirm that the wireless adapter is

installed correctly. Please refer to the Networking Basics section in

this manual entitled: Checking the Installation of the Drivers for the

Wireless Adapter.

5. By default, the wireless adapter is set to obtain a Dynamic IP

Address. If you are having difficulty connecting, check to make sure

that the IP Address of the wireless adapter is within the IP address

range of your network. Please refer to the Networking Basics

section in this manual entitled: Checking the IP Address.