Specifications

Conceptronic Wireless 54Mbps USB Adapter
LEDs
Your new C54RU has two LEDs on the antenna housing, so they can be seen when
the C54RU into a USB slot in your desktop computer.
The two LEDs operate in concert to inform you about the status and activity of your
C54RU.
When the two LEDs flash alternately, the C54RU is searching for a wireless network
connection − either to an Access Point or to another WLAN NIC.
When both LEDs flash in unison, there is a valid wireless network connection, and
there is activity over the link (data is being transferred). If the C54RU has
established a valid wireless network connection, but there is no activity, the two
LEDs will flash in unison, but much more dimly.
When the C54RU is disabled, only the Link LED flashes.
The following chart describes the full functions of the two LEDs.
The two LEDs are labeled Link and Act (Activity), as shown below.
What the LEDs are
doing
What that means
LEDs are flashing
alternatively
The C54RU is
searching for a
wireless network
connection.
LEDs are flashing in
unison
The C54RU has made
a valid wireless
network connection,
and there is activity
on the link.
LEDs are flashing in
unison, but dimly
The C54RU has made
a valid wireless
network connection,
but there is no
activity on the link.
This could be caused
by an Access Point
that is functioning,
but not connected
to the wired
network.
Only the Link LED is
flashing
The C54RU has been
disabled.
Only the Link LED is
flashing, but slowly
The C54RU has
entered its Power
Save Mode.
A
ct
Link
3