Specifications

Conceptronic Wireless 54Mbps USB Adapter
This type of installation requires that you provide a dynamic IP address for each
computer on your network. You will need a DHCP-capable Residential
Gateway/Router for your network.
To complete the installation, please follow these steps:
1. Connect the Router/Gateway to a Broadband connection (e.g., a
Cable modem or a DSL modem.)
2. Connect the 802.11g Access Point to the router.
3. Install the C54RU Wireless 54Mbps USB adapter into a laptop or
desktop computer on your wireless network
4. Check the Device Manager to confirm that the wireless adapter is
installed correctly. Please refer to the Networking Basics section in
this manual entitled, Checking the Installation of the Drivers for the
Wireless Adapter.
5. By default, the wireless adapter is set to obtain a Dynamic IP
Address. If you are having difficulty connecting, check to make sure
that the IP Address of the wireless adapter is within the IP address
range of your network. Please refer to the Networking Basics section
in this manual entitled, “Checking the IP Address.”
2. A Home Internet Network with Multiple IP Addresses
(Network administrators with Static IPs can also follow these instructions.)
If you have two or more computers (laptops or desktops) and want to share files,
printers, and Internet access using multiple IP addresses that you have purchased
from your Internet Service Provider -or- you want to connect to an Ethernet
network that uses Static IP Addresses, then follow the instructions on the next page.
When you have completed your network, it should look similar to this:
38