Wireless Broadband Router User Manual

Conceptronic C300BRS4 User Manual

5. Choose the desired Connect mode select setting. Select from: Always on, Manual, or Connect

on demand. Most users will want to choose the default connection setting, Always on.

6. When you are satisfied that all the WAN settings are configured correctly, click on the Apply

button.

7. The new settings must be saved and the Router must be restarted for the settings to go into

effect. To save and reboot the Router, click on the Tools directory tab and then click the

System button. In the System Settings window, click the Save button under Save Settings to

Local Hard Drive and then click the Reboot button under Reboot the CONCEPTRONIC

C300BRS4.

8. The Router will save the new settings and restart. Upon restarting the Router will

automatically establish the WAN connection.

Additional settings for PPPoE/PPPoA connections:

PPPoE/PPPoA Parameters Description

User Name For PPP connections, a User Name and Password are used to identify

and verify your account to the ISP. Enter the User Name for your ADSL

service account. User names and passwords are case-sensitive, so

enter this information exactly as given to you by your ISP.

Password Together with the User Name, this is used to verify your account to

the ISP. Enter the Password exactly as given to you by your ISP.

MTU The Maximum Transmission Unit size may be changed if you want to

optimize efficiency for uploading data through the WAN interface. The

default setting (1492 bytes) should be suitable for most users. Some

user may want to adjust the setting to optimize performance for

wireless traffic or when low latency is desired (such as with Internet

gaming). It is highly recommended that the user research how

adjusting the MTU may affect network traffic for better or worse.

IP Address If you have selected the Static PPPoE option, type in the global IP

address used for your WAN interface. Your ISP should provide this IP

address to you.

MAC Address To use the Clone MAC Address feature, enter a MAC address in this

field and then click the Clone MAC Address button.

Primary DNS Enter the Primary DNS Address. This information should be provided to

you by your Internet Service Provider.

Maximum Idle Time A value of 0 means that the PPP connection will remain connected. If

your network account is billed according to the amount of time the

Router is actually connected to the Internet, enter an appropriate Idle

Time value (in minutes). This will disconnect the Router after the

WAN connection has been idle for the amount of time specified.