User`s manual
ENGLISH
33
5. Modem router configuration
This chapter describes how to configure the C150APRA2 using the built-in Quick Start Wizard. After
completing the steps in this chapter your router has been set up for an ADSL connection and will be able
to connect to the internet.
5.1 Factory default settings
The C150APRA2 is preconfigured with several settings. The preconfigured settings can be found below:
IP Address : 192.168.0.1 (DHCP Server for LAN/WLAN clients Enabled)
Username : admin (select this user)
Password : admin (small characters)
Wireless SSID : C150APRA2
Wireless Channel : Channel 6
Wireless Security : WPA2
UPnP : disabled (can be enabled when internet connection is configured)
When you have changed settings in the configuration of the C150APRA2, they will be saved to the memory
of the router. To restore the factory default settings, press and hold the reset button on the back of the
device for +/- 15 seconds.
5.2 Web-based configuration
The configuration of the C150APRA2 is web based. You will need a web browser for the configuration of
the device.
Note: For configuration of the router it is advised to use a LAN cable connection to the device instead of a
wireless connection.
A. Start your web browser (like: Internet Explorer, FireFox, Safari or Chrome).
B. Enter the IP address of the device in the address bar of your web browser (by default:
http://192.168.0.1/).
C. You will first get a login window asking you for a Useradmin
from the dropdown list, enter the password for the administrator (default = adminlick
Login-based configuration.