User manual

CONCEPTRONIC C150APRA2 ENGLISH
65
The following table describes the parameters in this page.
Field
Description
Traffic Class Name
Enter the name of the traffic class.
Enable Classification
Select or deselect the check box to enable or disable QoS
classification.
SPECIFY TRAFFIC CLASSIFICATION RULES
Field
Description
Classification Type
Select L1&L2 or L3&L4 from the drop-down list.
 L1&L2 maps to the features of layer 1 and layer 2, such as
the MAC address.
 L3&L4 maps to the features of layer 3 and layer 4, such as
the IP address and the port.
Physical Lan Port
Select the physical port of the packet from the drop-down list.
For example, ethernet1, ethernet2, ethernet3, and ethernet4.
Source MAC Address
Enter the source MAC address of the packet.
Source MAC Mask
Use mask 000000ffffff to mask the MAC address. 00 indicates not
mapped and ff indicates mapped.
Destination MAC Address
Enter the destination MAC address of the packet.
Destination MAC Mask
Use mask 000000ffffff to mask the MAC address. 00 indicates not
mapped and ff indicates mapped
Ethernet Type
Select the layer 2 protocol type from the drop-down list. For
example, IP protocol and IPX protocol.
802.1p Priority
Select the 802.1p priority of the packet from the drop-down list.
You can select no assign or a value in the range of 0—7. Note that
this function is not supported at the moment.
SPECIFIC TRAFFIC CLASSIFICATION RESULT
Field
Description
Assign Classification
Queue
Specify the queue to which the packet belongs. You can set the
queue in the classification configuration.
Mark DSCP
Attach the DSCP mark to the mapped packet.
Mark 802.1p Priority
Attach the 802.1p mark to the mapped packet.
Click Apply to save the settings.