Operation Manual

MAC Filtering
The Bridge filtering page allows users to set the configuration of IP filtering.
Source MAC:
When the bridge filtering is enabled, enter the Source MAC address, select Block and
click Add. Then all incoming WAN and LAN Ethernet packets matched with this source
MAC address will be filtered out. If the Forward is selected, then the packets will be
forwarded to the destination PC.
Destination MAC:
When the bridge filtering is enabled, enter the Destination MAC address, select Block
and click Add. Then all incoming WAN and LAN Ethernet packets matched with this
destination MAC address will be filtered out. If the Forward is selected, then the
packets will be forwarded to the destination PC.
Type:
Enter the hexadecimal number for the Ethernet type field in Ethernet_II packets. For
example, 0800 is for IP protocol.