Operation Manual

ATM
VPI:
If instructed to change this, type in the VPI value for the initial connection (using PVC
0). Default = 0.
VCI:
If instructed to change this, type in the VCI value for the initial connection (using PVC
0). Default = 0
Service Category:
UBR and CBR are supported from the ATM.*
*Bandwidth:
Bandwidth setting takes effect only when the CBR is selected. The maximum available
bandwidth is from the upstream data rate of ADSL status page.
DHCP Client:
Use Table-1 to configure a valid setting for each PVC.
Host Name:
Required by some ISPs. If the ISP does not provided the Host name, please leave it
blank.
Table-1 Configuration
WAN
Configuration
Bridge Mode Router Mode
(PPPoA/PPPoE)
Router Mode
(Dynamic IP)
Router Mode
(Static IP)
IP address N/A Automatically
assigned by ISP
Automatically
assigned by ISP
Provided by ISP
Subnet Mask N/A Automatically
assigned by ISP
Automatically
assigned by ISP
Provided by ISP
WAN Type 1483 Bridged
IP LLC,
1483 Bridged
IP VC-Mux
PPPoA LLC/VC-
Mux,
PPPoE LLC/VC-
Mux
1483
Bridged/Routed
IP LLC,
1483
Bridged/Routed
VC-Mux,
Classical IP over
ATM
1483
Bridged/Routed
IP LLC,
1483
Bridged/Routed
VC-Mux,
Classical IP over
ATM
Bridge Enabled Disabled Disabled Disabled
PPP Service N/A Provided by ISP N/A N/A
PPP User
name
N/A Provided by ISP N/A N/A
PPP
Password
N/A Provided by ISP N/A N/A
DHCP Client
enable
Unchecked Unchecked Checked Unchecked