Installation guide

37
Static Routing
The Static Routing page enables you to define routes for specific subnets on the
WAN/LAN side. The RG allows you to manually program the RG's routing table. Up to
16 static routes can be added.
Choose a Connection: Select the LAN group or WAN connection to which a static
routing subnet is to be applied.
New Destination IP: The network IP address of the subnet. (You can also enter the
IP address of each individual station in the subnet).
Mask: The network mask of the destination subnet.
Gateway: The IP address of the next hop through which traffic will flow towards the
destination subnet.
Metric: Defines the number of hops the between network nodes that data packets
travel. The default value is 0, which means that the subnet is directly one hop
away on the local LAN network.
Click Apply to complete the setup. Click Save All to save the changes.