Installation guide

33
• Protocol
• TCP
• UDP
• TCP and UDP
• ICMP
• Any
Filter Name: Name of the IP filter rule you are creating.
Enable: The Enable button is checked by default, meaning this rule is automatically
applied when you click Apply.
Source IP: The LAN-side source IP address assigned to outgoing traffic on which
filtering is applied.
Source Netmask: Netmask of the source IP on your LAN side.
Destination IP: You can define the destination IP address to which your source IP will
be banned access. Enter 0.0.0.0 for all.
Destination Netmask: Netmask of the destination IP. Enter 255.255.255.255 for all.
Port Stat: The starting port number that will be blocked for this application.
Port End: The ending port number that will be blocked for this application.
Protocol: There are five options available: TCP, UDP, TCP and UDP, ICMP, and
Any.
Click Apply to complete the setup. Click Save All to save the changes.