Installation guide

27
ADVANCED
UPnP
Universal plug and play (UPnP), NAT, and firewall traversal allow traffic to pass
through the RG for applications using the UPnP protocol. This feature requires one
active WAN connection. In addition, the PC should support this feature. In the
presence of multiple WAN connections, select a connection on which the incoming
traffic is present, for example, the default WAN connection.
1. Check Enable UPnP.
This enables the WAN Connection and LAN Connection fields.
2. Select the WAN Connection and LAN Connection that will use UPnP from the
drop-down lists.
3. Click Apply to temporarily activate the settings.
Note— The changes take effect when you click Apply; however, if the RG
configuration is not saved, these changes will be lost upon RG reboot.
4. To make the change permanent, click Tools (at the top of the page) and select
System Commands.
5. On the System Commands page, click Save All.