Installation guide

CLIP Settings

1. At the Setup main page, click New Connection.

2. At the Type field select CLIP.

3. Enter a unique name for the static connection in the Name field. The name must

not have spaces and cannot begin with numbers.

4. The Network Address Translation (NAT) and the Firewall options are enabled

by default. Leave these in the default mode.

5. Based upon the information your DSL/ISP provided, enter your assigned IP

Address, Mask, ARP Server, and Default Gateway.

6. In the PVC Settings section, enter values for the VPI and VCI.

Note—Your DSL service provider or your ISP supplies these values.

7. Select the Quality of Service (QoS); leave the default value if you are unsure or

if the ISP did not provide this information.

The PCR, SCR, MBS, and CDVT fields are enabled / disabled depending on the

QoS selection. Enter the values provided by the ISP or leave the defaults.

8. Click Apply to complete the connection setup.