Installation guide

Bridge Settings

1. At the Setup main page, click New Connection.

2. At the Type field select Bridge.

3. Enter a unique name for the Bridged connection in the Name field. The name

must not have spaces and cannot begin with numbers.

4. In the Bridge Settings section, select the Encapsulation Type (LLC or VC).

Note— If you are not sure, just use the default mode.

5. In the PVC Settings section, enter values for the VPI and VCI.

Note—Your DSL service provider or your ISP supplies these values.

6. Select the Quality of Service (QoS). Leave the default value if you are unsure or

if the ISP did not provide this information.

The PCR, SCR, MBS, and CDVT fields are enabled / disabled depending on the

QoS selection. Enter the values provided by the ISP or leave the defaults.

7. Click Apply to complete the connection setup.