Installation guide

DHCP Settings

1. At the Setup main page, click New Connection.

2. At the Type field select DHCP.

3. Enter a unique name for the DHCP connection in the Name field.

The name must not have spaces and cannot begin with numbers.

4. The Network Address Translation (NAT) and the Firewall options are enabled

by default. Leave these in the default mode.

5. If your DSL line is connected and your DSL/IPS provider is supporting DHCP, you

can click Renew and the gateway retrieves an IP Address, Subnet Mask, and

Gateway Address. At any time, you can release the DHCP address by clicking

Release, and renew the DHCP address by clicking Renew.

6. Under PVC Settings, enter values for the VPI and VCI.

Note—Your DSL service provider or your ISP supplies these values.

7. Select the Quality of Service (QoS). Leave the default value if you are unsure or

if the ISP did not provide this information.

The PCR, SCR, MBS, and CDVT fields are enabled / disabled depending on the

QoS selection. Enter the values provided by the ISP or leave the defaults.

8. Click Apply to complete the connection setup.