Installation guide

22
Static Settings
1. At the Setup main page, click New Connection.
2. At the Type field select Static.
3. In the Name field, enter a unique name for the Static connection.
The name must not have spaces and cannot begin with numbers.
4. The Network Address Translation (NAT) and the Firewall options are enabled
by default. Leave these in the default mode.
5. In the Static Settings section, select the Encapsulation Type (LLC or VC).
Note— If you are not sure, just use the default mode.
6. Based upon the information your DSL/ISP provided, enter your assigned IP
Address, Subnet Mask, Default Gateway (if provided), and Domain Name
Services (DNS) values (if provided).
7. For the static configuration, you can also select a Bridged connection or a
Routed connection.
8. In the PVC Settings section, enter values for the VPI and VCI.
Note—Your DSL service provider or your ISP supplies these values.
9. Select the Quality of Service (QoS). Leave the default value if you are unsure or
if the ISP did not provide this information.
The PCR, SCR, MBS, and CDVT fields are enabled / disabled depending on the
QoS selection. Enter the values provided by the ISP or leave the defaults.
10. Click Apply to complete the connection setup.