Operation Manual

ENGLISH
- 14 -
If you ever forget the password to log in, you should contact the dealer where you bought this product.
3.2.3 LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
LAN Port WAN Port
IP address 192.168.1.254
Subnet Mask 255.255.255.0
DHCP server function Enabled
IP addresses for
distribution to PCs
100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
(Actually, it can supports up to 253 users.)
PPPoE function is enabled to
automatically get the WAN
port configuration from ISP,
but you have to set username
and password first.
3.3 Information from ISP
Before you start configuring this device, you have to check with your ISP what kind of service is provided such as PPPoE,
PPPoA, RFC1483, IPoA, or PPTP-to-PPPoA Relaying.
Gather the information as illustrated in the following table and keep it for reference.
PPPoE VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, Service
Name, and Domain Name System (DNS) IP address (it can be
automatically assigned from ISP or be set fixed).
PPPoA VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, and
Domain Name System (DNS) IP address (it can be automatically assigned
from ISP or be set fixed).
RFC1483 Bridged VPI/VCI, VC-based/LLC-based multiplexing and configure this product into
BRIDGE Mode.
RFC1483 Routed VPI/VCI, VC-based/LLC-based multiplexing, IP address, Subnet mask,
Gateway address, and Domain Name System (DNS) IP address (it is fixed
IP address).
IPoA VPI/VCI, IP address, Subnet mask, Gateway address, and Domain Name
System (DNS) IP address (it is fixed IP address).
PPTP-to-PPPoA Relaying VPI/VCI, VC-based/LLC-based multiplexing, and Domain Name System
(DNS) IP address (it is fixed IP address).