Operation Manual

ENGLISH
- 13 -
3.2 Factory Default Settings
Before you configure the ADSL Router, you need to know the following default settings.
1. Web Configurator
Password : <BLANK>
BLANK means user does not need to input any characters.
2. Device IP Network settings in LAN site
IP Address : 192.168.1.254
Subnet Mask : 255.255.255.0
3. Router/Bridge mode
Router
4. ISP setting in WAN site
PPPoE
5. DHCP server
DHCP server is enabled.
Start IP Address : 192.168.1.100
IP pool counts : 100
3.2.1 Router/Bridge Mode
The default mode is Router Mode. If you want to switch between the two modes, click on Advanced ? Router/Bridge
Mode in the left pane. Select the mode you want to use, and then click the “Apply” button.
3.2.2 Password
The password is left blank as the default setting. When configuring your ADSL Router with Web browser, just click “OK”, and
then you are logged in for the first time. It is recommended that you set a password for security and management purpose.
The ADSL Router maintains the password only. It means the ADSL Router only checks the password even you enter
characters in the User Name field.