Installation guide

ENGLISH
28
5.3 Maintenance
Select at the left side “Maintenance” to enter the Maintenance setup Page.
Options to select in the Maintenance setup Page:
- Firmware Upload
o If there is new firmware released through the webpage of Conceptronic you can upload
it from this page into the Conceptronic Grab’n’ GO network disk.
o “Browse” (A) the location of the firmware file and press “Upload” (B) to update the
Network disk.
- System Reboot
o After you have updated the firmware you need to reboot the device. A reboot can take
up to 1 minute before you can logon again.
o Press “Reboot” (C) to reboot the device.
- Factory Defaults
o You can reset the device back to factory defaults. After the reset you need to reboot the
Network disk again with the option ‘System Reboot’.
o Press “Reset” (D) to reset the device back to factory settings.
A B
C
D