Installation guide

ENGLISH
22
4. Hardware Installation
The Grab’n’GO Network Harddisk can be used in 2 ways:
- As external Harddisk for your computer; in this mode, the Harddisk only works as external
storage, not as Network Harddisk.
- As Network Harddisk; in this mode, the Network Harddisk is connected to your network and is
accessible through the network environment.
4.1 Using the device as USB 2.0 Harddisk
• Connect the Power Supply to the device and to a free AC power outlet.
• Connect the delivered USB 2.0 cable to the Conceptronic Grab’n’GO Network disk and
insert the cable into a free USB 2.0 port at the front or back side of your computer.
• Turn the power on by switching the power connector (backside of the device).
• Power-on your computer and the device will automatically detected by your computer.
Note:
If the LAN Disk is delivered with Harddisk it is already pre-formatted to FAT32 and you
can use it directly as external Harddisk.
4.2 Using the device as Network Harddisk
• Connect the Power Supply to the device and to a free AC power outlet.
• Connect the delivered LAN cable to the Conceptronic Grab’n’GO Network disk and to your
Network Switch or Router.
• Turn the power on by switching the power connector (backside of the device).
• Follow the steps of Chapter 5 to configure the CHD3NET.
4.2 4.1