User`s manual
8
2-2-3. Connecting to Web Management Interface
All functions and settings of this access point must be configured via web management interface. Please start
your web browser, and input ‘192.168.0.2’ in address bar, then press ‘Enter’ key. The following message should
be shown:
Please input user name and password in the field respectively, default user name is ‘admin’, and default
password is ‘admin’, then press ‘OK’ button, and you can see the web management interface of this access
point:
Note: If you can’t see the web management interface, and you’re being prompted to input user name and
password again, it means you didn’t input username and password correctly. Please retype user name
and password again. If you’re certain about the user name and password you type are correct, please go
to ‘4-1. Troubleshooting’ to perform a factory reset, to set the password back to default value.