User`s manual

5
Chapter II: System and Network Setup
2-1. Installing the access point to your network
Please follow the following instruction to build the network connection between your new wireless access point
and your computers, network devices:
A. Connect the access point to ADSL modem, router, or switch/hub in your network through the LAN port of the
access point by Ethernet cable.
B. Connect the A/C power adapter to the wall socket, and then connect it to the ‘Power’ socket of the access
point.
C. Please check all LEDs on the front panel. ‘PWR’ LED should be steadily on, LAN LEDs should be on if the
access point is correctly connected to the ADSL modem, router or switch/hub. If PWR LED is not on, or any
LED you expected is not on, please recheck the cabling, or jump to ‘4-1 Troubleshooting’ for possible
reasons and solution.
2-2. Connecting to wireless access point by web browser
After the network connection is built, the next step you should do is setup the access point with proper network
parameters, so it can work properly in your network environment.
Before you can connect to the access point and start configuration procedures, your computer must be able to
get an IP address automatically (use dynamic IP address). If it’s set to use static IP address, or you’re unsure,
please follow the following instructions to configure your computer to use dynamic IP address: