User`s manual

23
Here are descriptions of every setup item:
Enable WPS Check this box to enable or disable WPS function
Wi-Fi Protected Setup Information All information related to WPS will be displayed here, they’re helpful
when you’re setting up connections by WPS.
WPS Status:
Displays WPS status. If data encryption settings
of this access point has never been set,
‘unConfigured’ message will be displayed her.
(see Section 2-7 for detailed information); if
data encryption settings has been set before,
‘Configured’ message will be displayed here.
PinCode:
This is the WPS PIN code of this access point.
This code is useful when you need to build
wireless connection by WPS with other WPS-
enabled wireless devices.
SSID:
Displays the SSID (ESSID) of this access point.
Authentication Mode:
The wireless security authentication mode of
this access point will be displayed here. If you
don’t enable security function of the access
point before WPS is activated, the access point
will auto set the security to WPA (AES) and
generate a set of passphrase key for WPS
connection.
Passphrase Key:
Displays the WPA passphrase here, all characters
will be replaced by asterisk for security reason.
If encryption is not set on this access point,
nothing will be displayed here.
Config Mode There are ‘Registrar’ and ‘Enrollee’ modes for the WPS connection.
When ‘Registrar’ is enabled, the wireless clients will follow the access
point’s wireless settings for WPS connection. When ‘Enrollee’ mode is
enabled, the access point will follow the wireless settings of wireless
client for WPS connection.
Start PBC Click ‘Start PBC’ to start Push-Button style WPS setup procedure. This
access point will wait for WPS requests from wireless clients for 2
minutes. The ‘WLAN’ LED on the access point will be steady on for 2
minutes when this access point is waiting for incoming WPS request.
Start PIN Please input the PIN code of the wireless client you via client wish to
connect, and click ‘Start PIN’ button. The ‘WLAN’ LED on the access
point will be steady on when this access point is waiting for incoming
WPS request.
Note:
When you’re using PBC type WPS setup, you must press ‘PBC’ button (hardware or software) of wireless
client within 120 seconds; if you didn’t press PBC button of wireless client within this time period,
please press ‘PBC’ button (hardware or software) of this access point again.