User`s manual

Here are descriptions of every setup item:

Band Please select the wireless band you wish to use. By selecting different band setting, you’ll

be able to allow or deny the wireless client of a certain band.

• If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz (G), only wireless clients using the

wireless band you select (802.11b, 802.11 Draft-N, or 802.11g) will be able to connect to

this access point.

• If you select 2.4GHz (B+G), then only wireless clients using 802.11b and 802.11g band

will be able to connect to this access point.

• If you want to allow 802.11b, 802.11g, and 802.11 Draft-N clients to connect to this

access point, select 2.4GHz (B+G+N).

Channel Number Please select a channel number you wish to use. The channel number must be same with

another wireless access point you wish to connect

MAC address 1 ~ 4 Please input the MAC address of the wireless access point you wish to connect

Set Security Click this button to select an encryption mode for this wireless link, a new popup window

will appear. Please refer to Section 2-7 for detailed descriptions.

After you finish with setting, please click ‘Apply’, and the following message will be displayed:

When you see this message, the settings you made is successfully save. You can click ‘Continue’ button to back

to previous page and continue on other setting items, or click ‘Apply’ button to restart the wireless access point

and the changes will take effect after about 30 seconds.