User`s manual

2-4-3. AP Bridge-Point to Point Mode

In this mode, this wireless access point will connect to another wireless access point which uses the same mode,

and all wired Ethernet clients of both wireless access points will be connected together. You can use this mode

to connect a network to another network which is physically isolated.

Please note that when you set your access point to this mode, it will not accept regular wireless clients

anymore.

When you select ‘AP Bridge-Point to Point’, the following options will be displayed:

Here are descriptions of every setup item:

Band Please select the wireless band you wish to use. By selecting different band setting, you’ll

be able to allow or deny the wireless client of a certain band.

• If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz (G), only wireless clients using the

wireless band you select (802.11b, 802.11 Draft-N, or 802.11g) will be able to connect to

this access point.

• If you select 2.4GHz (B+G), then only wireless clients using 802.11b and 802.11g band

will be able to connect to this access point.

• If you want to allow 802.11b, 802.11g, and 802.11 Draft-N clients to connect to this

access point, select 2.4GHz (B+G+N).

Channel Number Please select a channel number you wish to use. The channel number must be same with

another wireless access point you wish to connect

MAC address 1 Please input the MAC address of the wireless access point you wish to connect

Set Security Click this button to select an encryption mode for this wireless link, a new popup window

will appear. Please refer to Section 2-7 for detailed descriptions.