User`s manual

53
5-12. Advanced - Traffic Control
Traffic control is used to limit communication speed in the LAN and WAN. Up to 20 entries can be supported with
the capability for at most 254 PCs' speed control, including for IP address range configuration.
Enable Traffic Control : To enable or disable the internal IP bandwidth control. The default is disabled.
Interface : To limit the uploading and downloading bandwidth in WAN port.
Service : To select the controlled service type, such as HTTP service.
IP Starting Address : The first IP address for traffic control.
IP Ending Address : The last IP address for traffic control.
Uploading/Downloading : To specify the traffic heading way for the selected IP addresses: uploading or
downloading.
Bandwidth : To specify the uploading/downloading Min. /Max. Traffic speed (KB/s), which cannot
exceed the WAN speed.
Apply : To enable the current editing rule. If not, the rule will be disabled.
Add : After edit the rule, click the “add to list” button to add the current rule to rule list.
Apply : Click “Save” to activate the current rule.
Cancel : Click “Cancel” to drop all setting saved last time.